← Back to Windermere

Windermere, Seattle WA

Windermere Corporation Fence Guide for Seattle

Planning a fence on a Windermere lot? Here is what the Windermere Corporation publishes about fences, deed covenants, and board review, alongside the City of Seattle's fence rules. Each fact links to its public source.

SeattleFence is an independent contractor. We are not affiliated with, endorsed by, or an approved vendor of the Windermere Corporation. Last checked against public sources on November 16, 2026. Rules change, so confirm current requirements with the Corporation and your deed before you build.

What is public about the Windermere Corporation

The Windermere Corporation's website says Windermere was established in 1910 as a residential neighborhood on the western side of Lake Washington, and that the Corporation is the community organization for the neighborhood. Membership is restricted to home owners in Windermere. The bylaws sit behind a member login, but the public Design, Land Use and Construction page links a two-page construction approval process and guidelines document (revised 2020).

Those documents tie review to the Windermere Deed covenants on each lot. They say deed restrictions and setback requirements are not identical on each property, and that a copy of your Windermere Deed is available through the King County Archives or sometimes your title company.

Published fence guidance

These points come from the Windermere Corporation's own pages and its 2020 guidelines document.

TopicWhat the source saysSource
Who reviewsOwners whose property is subject to Windermere Deed covenants and restrictions must get the Windermere Corporation's prior approval for exterior construction (Article VIII of the bylaws)Approval process (2020)
Privacy fencesFences at the property line for privacy are allowed under the same regulations as the City of SeattleGuidelines (2020)
Front yard setbackThe side fence may return to the house rather than extending out to the front property lineGuidelines (2020)
HeightNot specified in the Windermere covenants, deeds, or restrictions; City of Seattle height restrictions applyGuidelines (2020)
SetbacksAlmost all Windermere properties have different setbacks than the City of Seattle, and deed restrictions differ lot by lotDesign, Land Use and Construction
Items kept out of setbacksPer board guidelines: heat pumps or other equipment, trash can enclosures, and parking for trailers, boats, or RVsGuidelines (2020)

Board review process

The public documents describe this review for exterior construction on covenanted lots. They don't list fences by name, so ask the Corporation whether your fence needs to go through it.

  1. Contact the chair early

    The Corporation asks owners to contact the Design, Land Use and Construction chair at least 45 days before a project to renovate or replace any structure or permanent fixture.

  2. Gather your deeds

    The approval form asks for your Windermere Deed and Statutory Deed, showing the covenants, restrictions, or variances for your lot.

  3. Submit a site plan and fee

    It asks for drawings with a site plan dimensioned to property lines, with the City and Windermere setback lines marked, plus the review fee listed on the form.

  4. Board decision in writing

    The chair recommends action at the next board meeting. The board meets once a month and tells the owner in writing whether plans are approved or what needs to change.

Sources: Design, Land Use and Construction and the 2020 approval process document. Where your deed or the board's current practice isn't covered there, go to the Corporation's review committee and your covenants for the answer.

Seattle fence rules

Since the Windermere guidelines defer to the City of Seattle on fences and height, these city rules from SDCI's fences page matter too.

TopicWhat the source saysSource
When no permit is neededFence 8 ft or under, with no masonry or concrete over 6 ft, and not in a flood-prone areaSDCI Fences
Height in residential zones6 ft, plus 2 ft of arbors or trellises; 4 ft in a front or street-side setbackSDCI Fences
Sloping sitesUp to 8 ft if the average height between posts is 6 ftSDCI Fences
Fence on a retaining wall that raises gradeCombined height capped at 9 ft 6 in.SDCI Fences

SDCI's Do You Need a Permit? page repeats the exemption for fences less than 8 feet high with no concrete or masonry elements higher than 6 feet. Work near an environmentally critical area, such as a wetland or steep slope, can have different restrictions.

Stepped fence panels on a sloping lotA side view of a sloped yard with fence panels that step down the hill so each panel stays level and the average height between posts stays within Seattle's limit.Panels step so average height stays at 6 feet
Original SeattleFence illustration, not a plan of any Windermere lot. On a sloping site, Seattle allows a fence up to 8 feet if the average height between posts is 6 feet.

Styles that usually fit covenant neighborhoods

General guidance only, not a Windermere rule. The Corporation's public guidelines don't name materials or colors for fences. SeattleFence project photos from the Seattle area; none show a Windermere home.

Cedar privacy fence

A finished, solid cedar face suits property-line privacy runs.

View this style →

Picture frame cedar

A framed top and bottom rail gives a tailored look from both sides.

View this style →

Cedar and hog wire

An open panel keeps light and views where full privacy isn't needed.

View this style →

Windermere fence questions

Is the Windermere Corporation an HOA?

The Windermere Corporation describes itself as the community organization for the Windermere neighborhood, with membership restricted to home owners in Windermere. Its published approval process says owners whose property is subject to Windermere Deed covenants and restrictions must obtain the Corporation's prior approval for exterior construction under Article VIII of its bylaws. It works like a covenant-review association for those lots. SeattleFence is not affiliated with it.

What does the Windermere Corporation say about fences?

Its Design, Land Use and Construction Guidelines say fences at the property line for privacy purposes are allowed under the same regulations as the City of Seattle. In the front yard setback, the side fence may return to the house rather than extending out to the front property line. The guidelines also say height restrictions are not specified in the Windermere covenants, deeds, or restrictions, so City of Seattle height limits apply.

Do I need Windermere board approval for a fence?

The public documents don't list fences by name in the approval process. The Corporation's Design, Land Use and Construction page asks owners to contact the chair at least 45 days before a project to renovate or replace any structure or permanent fixture, and says board approval is required before construction begins. Ask the Corporation's Design, Land Use and Construction chair, and check your Windermere Deed and covenants, before you build.

Do I need a City of Seattle permit?

SDCI's fences page says you don't need a permit for a fence 8 feet high or less that has no masonry or concrete elements over 6 feet, unless the fence is in a flood-prone area. Zoning height limits still apply: 6 feet in residential zones, 4 feet in a front or street-side setback.

Get Your Free Windermere Fence Quote

We'll plan the layout around Seattle's rules and give you a site sketch you can bring to the Corporation's review if your lot needs it. Backed by our 5-year craftsmanship warranty.

Get In Touch

Fill out the form and we'll get back to you shortly.

Type your address. Suggestions help, but a typed address still submits.

By clicking Send Message, you agree to receive calls and text messages from SeattleFence at the number provided, including automated messages, about your inquiry, appointments and fence updates. Consent is not a condition of purchase. Msg frequency varies. Msg & data rates may apply. Reply STOP to opt out or HELP for help. See our Privacy Policy.

Prefer to talk? Call (253) 766-5854